|
|
Hardware
 Metal Springs |
 Screw-In Hangers |
 Tapped Corner Screws |
 Bump-ons |
 Bulk Hardware with Springs |
 Back Corners |
Hardware
For Aluminum frames
Description |
IP-# | PER 100 | PER 1000 |
Hangers (screw-in) |
IP53401 | ||
Springs (metal) |
IP53403 | ||
| Tapped corners/screws | IP53404 | ||
| Back corners | IP53405 | ||
Clear Bump-ons |
BU-BS2CLRM |
N/A |
|
Bulk Hardware* |
IP-Bulk Hrd |
* Bulk Hardware includes: 400 tapped brackets with screws started and 400 blank brackets. This is enough corner hardware to assemble 100 frames. Springs, hangers and bump-ons are not included.
E-Z Hinge Aluminum Springs allow you to remove the top of an Aluminum frame without disassembling the entire frame. Makes changing the artwork in a frame simple. Comes in a set of 2.
SECURITY HANGING SYSTEM
Security T Screws |
IP-54806 | ||
Security Top Clips |
IP-54803 | ||
Security Wrench |
IP-50047 |
Designed for a wide variety of applications where safe and secure picture hanging is
necessary. Theft of valued artwork is minimized by needing a special security wrench to
remove the frame from the wall. The system works to keep a picture straight and firmly
mounted on the wall. Two bolts and two top clips are required for each frame. The security
wrench can be used, of course, over and over.
INSTRUCTIONS FOR SECURITY HANGING SYSTEM
1) Mount the two security top clips on the wall.
2) Suspend the frame on the two top clips and then lower the frame over the security bolt.
3) Engage the security wrench on to the neck of the security bolt.
4) Rotate the wrench 90 degrees.
5) Remove the wrench, and the picture is secured.
 |
Aluminum
Frame Sawtooth Hangers IP-53420C Sawtooth Snap in Hangers
|